The operation steps as follows
1.Add more than 30% water into the glaze lump, mix completely and leave for over 2hours.
2.Loading the glaze into mill machine grind 2 hours.
3.removing iron and filtration , sieving through 200 mesh.
4.adjust density to 60-65 degree.
5. keep the high gap at the 1-1.5 meters from the glaze tub to spray gun.
6.install a pressure regulator in front of spray gun, and adjust the pressure at the 0.8-1.2mm.
7.after glaze firing temperature reach to setting degree. Keep heat on 20-25 minutes.
8.after heat preservation open the kiln door by a third.
9.quickly cool itself. The glaze will achieve to good effect.

操作步驟如下：
1.將30%以上的水加入釉塊內，平均浸泡2小時以上
2.將釉料裝入球磨機內磨2小時.
3.除鐵和過濾，通過200目篩。
4.調整濃度為60-65度.
5.釉桶與噴槍高位差距為1-1.5米。
6.在噴槍前安裝壓力調節器，調節壓力為2Mpa,噴釉厚度為0.8-1.2mm.
7.釉燒后溫度達到設定度，保溫20-25分鐘。
8.保溫后，將窯門打開三分之一。
9.即速自然降溫，釉面達到更佳效果